GfS Terminal Stainless Steel

GFS Electric Door Locks The electric lock operates on the fail-safe principle. The electric door locking system consists of a locking element (surface-mounted magnet, emergency exit strikes, bolt lock, etc.), a control unit (e.g., GfS Door Terminal, GfS FWS 02), a release element (e.g., GfS e-Bar, GfS Door Terminal, emergency switch), and according to prEN13637, an operating element (door handle, panic bar, etc.). When the release element is activated, the locking element is de-energized and unlocked. The GfS Door Terminal (with integrated control unit, siren, strobe light, and emergency switch) is to be mounted near the door or on the door leaf. The height of 1200 mm should not be exceeded during installation. The recommended optimal height is 850 mm so that children and wheelchair users can also reach the switch. The surface-mounted magnet is mounted on the door frame or in the passage area, and the holding plate is mounted on the door leaf. During installation, the clear passage height of 2 m must not be undercut. Surface-mounted magnets are easy to install and can also be retrofitted to existing doors (surface mounting). No changes or cutouts need to be made to the door frames. This statement does not apply to the retrofitting of fire protection closures with smoke protection properties. According to a letter dated 1.12.2009 from the Institute for Building Technology (Berlin), electromagnets can only be retrofitted to fire protection closures with the approval of the door manufacturer. In these cases, the security door closer with an integrated electric locking element may be an option. The emergency exit door is electrically locked, the red backlit emergency button for unlocking is alarm-secured. In an emergency, the red backlit emergency buttonis pressed. The LEDs blink green. The electriclock is de-energized. The emergency exit door can be used. At the same time, a visualand an acoustic alarm (95 dB/1 m) are triggered.These can be reset with the device key. Authorized persons do not use the handle,but open the latch with the key,to pass through the door without triggering the alarm.

Additional board for the GfS door terminal when using 2 terminals on one door

top and bottom (W x H x D): 90 x 240 x 20 mm

MPA approval according to EltVTR Rated voltage: 30 V/DC max. Rated current: 2A max. includes reusable plastic cover and pictogram for connection to escape route control FWS-02

For the installation of the GfS door terminal for flush mounting.

Protective cage for the terminal 

Mounting Plate for GfS Door Terminal Stainless Steel, Installation Aid

Clear protective cover for the emergency switch of the GfS terminal made of transparent plastic.

Type PZBC01NT attachable

Type PZPC01NT attachable

Self-adhesive film long-lasting glow 95 mm x 140 mm according to EltVTR

self-adhesive film green 95 mm x 140 mm acc. to EltVTR